|
|
|
|
| INST/R-1301
|
Wideband Analog Transmission |
|
 |
| For Wideband Analog
Instrumentation Applications |
|
|
|
|
The LuxLink™ INST/INSR-1301 system consists of the INST-1301 transmitter and
INSR-1301 receiver. Both units utilize intensity modulation (IM) to transmit
wideband analog signals for a host of laboratory and instrumentation
applications.
Both multimode and single-mode versions are available and installation only
requires a simple one-minute calibration adjustment. In addition, integral
indicators are provided on both units to continuously indicate the presence of
repetitive signals as well as the presence of operating power making system
troubleshooting simple.For a lower bandwidth, lower cost unit see the
INST/R-1001 |
| |
| Specifications |
|
|
Important Features |
| System Bandwidth (min) |
30 MHz (+0,-3dB) |
|
· 30 MHz Signal
Bandwidth |
| Input/Output Impedance |
50 ohms |
|
· Cost effective |
| Input Level |
1 Volt pp |
|
· Signal & Power
Indicators |
| Output Level |
1 Volt pp (3V if 10K load) |
|
· Multimode &
Single mode |
| Signal/Noise Ratio |
60 dB minimum |
|
Versions available |
| Dynamic Range |
58 dB minimum |
|
|
| Linearity |
3.0% maximum |
|
|
| Phase Shift |
3.0º maximum |
|
|
| System Delay |
25ns + 1ns/foot of fiber |
|
|
| Optical Output Power |
-16 dBm (multimode),
-16 dBm (single-mode) |
|
|
| Optical Loss Budget |
0-13 dB (multimode),
0-13 dB (single-mode) |
|
|
| Signal Connectors |
BNC |
|
|
| Power Requirements |
11-24 VAC/DC @150ma |
|
|
| Operating Temperature |
-35 to +75 degrees C |
|
|
| Physical Size |
5.0” x 3.0 x 1.0"
127mm x 76mm x 25.4mm |
|
|
*Note all specifications are subject to change without notice
Copyright 2008
|
Fiber Optic Communications Systems
