|
|
|
|
| IRGC-3003 |
IRIG Format
Converter |
|
|
| For IRIG Signal Format
Conversion |
|
|
|
|
The IRGC-3003 is IRIG format converter,
converting
modulated IRIG to/or from DCLS IRIG. There is one a buffered IRIG
input with loop through output, and three individual converted electrical output
signals. IRIG A, B, & E are supported. Mode of
operation (type of conversion) and carrier resolution is selectable via a
front panel dip switch.Integral indicators are provided to continuously indicate the presence
of IRIG signal as well as the presence of operating power making system
troubleshooting simple. Optional ALM-1000 can be utilized if alarm outputs
are required. Units can be mounted in our 1U, 2U, or 3U rack
panels.
For optical
IRIG distribution amplifier see the IRGM-1004 or
IRGM-7004.
For non-format converting distribution see the
IRGM-2004 or the IRGM-8004. |
|
|
| Specifications |
|
|
Important Features |
|
Formats |
Modulated or DCLS IRIG |
|
· 1 Loop
Through |
|
Protocols |
IRIG A, B, & ,E; |
|
· 3 Outputs |
Modulated
Signal Bandwidth (min) |
100Hz to 100KHz (+0,-3dB) |
|
· Cost effective |
Modulated
Input / Output Impedance |
600 ohms |
|
· Signal & Power
Indicators |
Modulated
Input / Output Level |
6 volt pp maximum |
|
· Rack or wall
mountable |
Modulated
Signal/Noise Ratio |
60 dB minimum |
|
|
DCLS
Input / Output Impedance |
50 ohms |
|
|
DCLS
Input / Output Level |
3.5 volts typical (TTL) |
|
|
DCLS
Data Rate |
DC to 1000 Pulse Per Sec |
|
|
|
Linearity |
2.0% typical |
|
|
|
Signal Connectors |
BNC |
|
|
|
Propagation Delay |
5 ns |
|
|
|
Offset between outputs |
< 0.5 ns |
|
|
|
MTBF (Mil-HDBK-217D) |
>100,000 Hours |
|
|
|
Operating Temperature |
-35º to +75º
C |
|
|
|
Power Requirements |
11-24 VAC/DC @250 mA |
|
|
|
Operating Temperature |
-35 to +75 degrees C |
|
|
|
Physical Size |
5.0” x 3.0 x 1.0"
127mm x 76mm x 25.4mm |
|
|
|
|
|
|
*Note all specifications are subject to change without notice
Copyright 2008
|
Fiber Optic Communications Systems
