Home  
Map  
INST/INSR-1301     Wide-Band Analog   Click for Lager picture of Analog Fiber Link.
For Cost-effective  Analog Instrumentation Applications  

INST/R-1301 Fiber Optic System Application   


The Luxlink© INST/INSR-1301 system consists of the INST-1301 transmitter and INSR-1301 receiver. Both units utilize intensity modulation (IM) to transmit wideband analog signals for a host of laboratory and instrumentation applications.

Both multimode and single-mode versions are available and installation only requires a simple one-minute calibration adjustment.  Integral indicators are provided on both units to continuously indicate the presence of repetitive signals as well as the presence of operating power making system troubleshooting simple.

 
 
Specifications Important Features
System Bandwidth  20 Hz to 30 MHz (+0,-3dB)    · 30 MHz Signal Bandwidth
Input/Output Impedance  50 ohms  • Very Cost-effective
Input Level  1 Volt pp  • Signal & Power Indicators
Output Level  1 Volt pp (3V if 10K load)  • Multimode & Single mode
    versions
Signal/Noise Ratio  60 dB minimum  • Stand-alone, DIN or Rack
    Mountable (same unit)   
Linearity  3.0% maximum  
Phase Shift  3.0° maximum
System Delay  25ns + 1ns/foot of fiber
Rise/Fall time 15 ns minimum    
Operating Wavelength 850, 1310 or 1550nm    
Optical Loss Budget  0-13 dB (multimode),
 0-13 dB (single-mode)		    
Optical Connectors ST (multimode)
FCPC (single-mode)
Signal Connectors  BNC
Power Requirements  11-24 VAC/DC @150mA
Operating Temperature -35 to +75 degrees C
Humidity <95% non-condensing    
MTBF (per MIL HBK 217) >120,000 hours    
Physical Size (mm)  5.0" x 3.0" x 1.0"
(127mm x 76mm x 25.4mm)		    

Note all specifications are subject to change without notice

Copyright 2025

LuxLink

Voice: 1-516-931-2800

Email: Contact Us